UTStarcom PPC 6700 Manuel d'utilisateur télécharger pdf (Page 84)

Getting Connected | 83

Connect to a Wi-Fi network

1. On the Comm Manager screen, tap the Wi-Fi button to turn on/off the wireless function.

2. Tap Settings > Wi-Fi Settings to conﬁgure the required settings. When the

conﬁguration is completed, you can connect to a Wi-Fi network using your device.

Note Tap the Network Cards icon ( ) on the Wireless LAN Settings screen to open the

Configure Wireless Networks screen, which allows you to configure wireless networks

and network adapters.

To save battery power while connected to a Wi-Fi network

1. On the Settings tab of the Wireless LAN Settings screen, move the Power Save Mode

slider to a position that optimizes performance with the least power consumption.

2. Select the Auto turn off WLAN if not connected check box to allow your device to

turn off the WLAN function automatically when no signal is detected.

To increase security of the Wi-Fi network

The LEAP (Lightweight Extensible Authentication Protocol) feature of Wireless LAN

increases security on your device, and ensures that nobody is able to access your network

without your permission.

1. On the Wireless LAN Settings screen, tap the LEAP tab.

2. Tap New. By default, the LEAP screen displays data that you entered previously.

However, you can modify or delete the data as required by tapping Modify or Delete.

3. Enter the SSID (Service Set Identiﬁer).

4. Enter the user name, password, and domain.

5. Select an Authentication Type. By default, the Authentication Type for your device is

Open System.

Note For LEAP to work correctly, both the access point and the receiving device (your device)

must be set with the same SSID, user name, and password.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 148 149

Pas de commentaire

UTStarcom PPC 6700 Manuel d'utilisateur Page 84